Our maytag maxima steam washer has a flashing yellow light next to door locked the door won t open and the machined cannot be turned on.
Maytag front load washer door locked flashing.
With a 10 year limited parts warranty 1 you can trust that a maytag front load washer has the power and perseverance to keep your clothes clean load.
The lid will lock and the machine will enter a pump out mode for 8 minutes.
This is a page about unlocking the door on a maytag front load washer.
Wait approximately 2 minutes for control to reset.
To unlock the controls press and hold the cycle end signal for 3 deliberate seconds or until the control lock light goes out.
Shop maytag front load washers to find options like the optimal dose dispenser so you only use as much as you need a sanitize cycle and even compact models with a stainless steel wash basket.
Nothing else will appear to be happening with the machine during this time.
The door should unlock after 60 seconds.
Pull on this tab to manually unlock the door.
The door may immediately unlock.
After 8 minutes the door will unlock.
In some circumstances your new washer may arrive with the door locked.
The top panel will then pull straight back up and off.
The door lock light is blinking on my front load maytag maxima.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
This is all it will do.
The door lock led light will blink.
Run a drain and spin cycle.
When using one of these cycles the door will remain locked until the cancel button is pushed.
If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.
If it still won t work then unplug the washer and remove the screws coming in from the back of the top panel.
During this period you will be able to hear the pump running.
Click here for more information on how to unlock your washer door when locked at the time of installation were you using a fresh hold cycle available on some models.
If it does not detect both water supply hoses are turned on the control detects a problem with the water pressure sensor.
Now you can reach down to the bottom of the door latch where there is a 1 round plastic tab.
This can occur from the normal shipping movement.
If the control locked light will not turn off i recommend unplugging the washer for 5 minutes.
First it had a code blinking that i looked up and it was for the water so i turned it on and now it is making a humming noise and the door is locked and that is all it will do.
The washer will go into a hold and drain routine for 8 minutes.
Maytag washers 3 answers from these members.
